On the Otis XO21NP and XO-508 escalators, the nameplate is located on the lowest landing beside the handrail and it clearly shown the manufacture date and its serial number. For example, there are some older Otis elevators with serial numbers that starts with two digit numbers followed by three letters and then a three digit numbers (example "00 XXX 000"). There are known examples of Kone maintaining Gen2s and using it as their registration number for maintenance.Ĭertain older European Otis elevator models have slightly different serial number format. Most Australian Otis Gen2s maintained by Otis display their serial number as the Machine Number. The Otis 2000 VF with 2000 fixtures, indicate its serial number (C3NE1001) and the year of manufactures (1998), which installed in Indonesia.įor Otis GeN2 elevators with large LCD displays in Spain, both the serial number and build year are listed on the display, usually near the bottom left corner of the screen. The first two digit consist of numbers, followed by three digit letters and three digit numbers at the end (example: "00XXX000").Same as above, but the first two digit only consist of numbers (example: "00XXX000").The first two digit consist of a letter and a number, followed by three digit letters and three digit numbers at the end (example: "X0XXX000"). (HK) Ltd.) followed by two letter and then four digit numbers (example: "00XX0000"), although some other elevators may have either of the following different formats: These elevators use 8 digit serial number, usually starts with two digit numbers (which represent a country code (and the company of installation), for example, 31 for Otis Australia, and 51 for Otis Elevator Co. On Otis 2000 and European Gen2 elevators, both the serial number and build year are listed along with the capacity just under the floor indicator. Otis Europa 2000 elevator with serial number 73 KL 6699 (note the different letters in the middle) Otis 2000 and European GeN2 Serial numbers and built years will be found on an plate with their logotype with it. If Kone are or were previously contracted to maintain a non-Kone elevator, the same eight-digit serial number format used for MonoSpace and related Kone models will be assigned to that lift (see below section). Note that in Australia, the number listed on the indicator is often known as the Equipment Number. After 2001, they used 8-number digits instead. This also applies on Kone marine elevators in cruise ships and cruise ferries built under the MacGregor brand (these marine elevators often have the words "Manufactured By KONE" listed on the bottom of the panel). KONE list their serial numbers before 2001 with the letter H followed by an number. Most of the examples shown here are from Finland and Sweden. On Kone elevators, there are numerous ways to identify the serial numbers and built years. The serial number isn't that much different. The latter serial numbers were even used by KONE in the early 1970s in Sweden as well as KONE Asea-Graham between 19.Īn older ASEA sticker before the merge. You have to rely on the inspection cerificate and if the elevator have swing doors, there might be a built year stated in there.īut if you visit the machine room, however, there will be a plate on the main control cabinet's short side showing both built year and serial number (stated as Reference number here)ĪSEA-Graham list their numbers in two ways either 8-number digit with a dot in the middle (XXXX.XXXX), or a 7-number digit starting with letter L (L-XXX.XXXX). On elevators made by ASEA-Graham in Sweden, there are usually no spots were you can find any serial numbers or built year at all within the cab. Here is a list of elevator brands and models, how an serial number of a certain brand are arranged and where to find the serial numbers and built year within the cab, machine room and elevator shaft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |